Skip to main content
Loading…
This section is included in your selections.

The final map shall include the following:

A. A scale large enough to show details clearly, minimum scale of one hundred feet to the inch or larger, using more than one sheet if necessary. The original shall be drawn in black ink upon tracing cloth or polyester base film of good quality. The size of the sheets shall be eighteen inches by twenty-six inches, and all sheets shall have a one inch margin on all borders.

B. Numbered sheets showing the relation of one sheet to another shown.

C. A map title consisting of a tract number and name, conspicuously placed at the lower right-hand corner of the sheet followed by the words, “consisting of ________ sheets” (showing the number thereof), followed by the words, “City of Marina”. If more than two sheets are necessary, an index diagram shall be provided.

D. A subtitle that generally describes the property being subdivided using references to previously filed or recorded maps, or the plat of any state or U.S. survey. Each reference in such description shall be identical to the original record and reference the book and page of the record referenced.

E. Border lines and center lines of all proposed streets with their widths and names; all easements including those to be dedicated to public use; vertical and lateral accessway easements shall be reviewed by a qualified biologist and/or geologist and easements shall be dedicated to the public as determined by the city unless otherwise specified in the local coastal program and in the approval of the tentative map. The exterior boundaries of the land in the subdivision shall be shown by a border one-eighth-inch wide.

F. The lines of all adjoining properties, streets and alleys, showing their widths and names.

G. All lot lines and numbers for all lots and letters for undevelopable areas. Building lines shall be shown if they differ from zoning requirements. All lots are to be numbered consecutively.

H. All dimensions, both linear and angular, for locating boundaries of subdivisions, lots, street and alley lines, easements and building lines. The linear dimensions shall be expressed in feet and hundredths of a foot.

I. All permanent monuments, together with their descriptions showing their location and size, and if any points were reset by ties, that fact shall be stated. Monuments shall be of a type and location per city standards and as prescribed by the standards set forth in Section 16.16.080 below.

J. Title and description of property being subdivided, showing its location and extent, north arrow, scale of plan, basis of bearing and name of subdivider and of engineer or surveyor who prepared the map.

K. The boundaries of any areas subject to periodic inundation by water or to geological hazards.

L. Ocean meander lines from recorded data when sufficient survey information exists on filed maps and when the location of any points can be established by monuments.

M. Scenic easements and open spaces if not shown as a lot or parcel shall be described by courses and distances and the basis of bearings shown. When a tentative subdivision map is approved with a prescribed net density and when final subdivision maps are filed in units, sufficient lot size plus open space in each unit to meet the approved net density shall be provided.

N. Any city boundary that adjoins the subdivision shall be designated and located in relation to adjacent lot or block lines. No lot shall be divided by a city or district boundary line.

O. Places where access rights have been waived or dedicated. (Ord. 2009-04 § 4 (Exh. A), 2009; Ord. 2007-08 § 4 (Exh. A), 2007)